ENGLISH
Genius Car Alarm
www.geniuscaralarm.com
25
Genius Car Alarm
www.geniuscaralam.com 3
Introduction
Thank you for purchasing our security system for your vehicle. Read well the user’s
manual of the system specifically the functions of the transmitter, the valet switch and the
LED indicator on the board.
The Transmitter
Each transmitter has a different code, the alarm system is programmed by the factory with
2 codes (2 transmitters), and you can program a maximum of 4 codes (4 transmitters). The
transmitter has 4 buttons, I, II, III, IV.
The system is pre-programmed with a work routine with each button of the transmitter.
It works with the following configuration:
Programming and memory of the transmitters and witnessed transmitters
The alarm system is designed to memorize up to 4 different transmitters, be careful when
programming a transmitter, the alarm system deletes from the memory the previous
transmitters, program all transmitters at the same time, since through this deletion function
you can delete the memory of any transmitter if it is lost by simply programming the
transmitter or transmitters again. The witnessed transmitter should be the last one to be
memorized.
To enter the memory and be able to program the transmitters, follow these steps:
1. Set the ignition switch in ON
2. Within the first 5 seconds after setting the ignition switch in ON, press and let go the
reset button 5 times, the siren will confirm with long sound, you have 10 seconds to
enter the transmitters, if you do not enter any transmitter before the 10 seconds or
set the ignition switch in OFF, the system will automatically exit the transmitter
learning mode and the siren will confirm with 2 sounds and the memory of the
transmitters will not be deleted.
3. Press and let go button I on the transmitter to program, the siren will confirm with 1
sound the memorization of the transmitter, as of that moment the old transmitters
will be deleted.
Button I
Button III
Button IV
Button II
