ENGLISH
Genius Car Alarm
www.geniuscaralarm.com
28
Genius Car Alarm
6 www.geniuscaralam.com
Silent Disarm
First press and let go button III and then press and let go button II on the transmitter to
disarm the alarm system silently, the system will disarm without the sound of the siren.
When silently disarmed and after the vehicle has been victim of a carjack attempt, the
siren will sound 3 times as an alert warning.
ARMING WITH ZONES’ CANCELLATION
This system allows us to arm the alarm cancelling the shock sensor as the 1
st
zone and
the shock sensor and doors’ signal as the 2
nd
zone. This is to avoid false alarm when the
shock sensor or the doors’ switch is triggered.
1. Press
button 1
, then press
button 3
within two seconds, the shock sensor is cancelled.
2. Press
button 1
, then press
button 2
within 2 seconds, both the shock sensor and the
door’s signal are cancelled.
DOORS’ SIGNAL ARMING DELAY
This function allows us to arm the alarm even when the dome lights are on, because the
system will not recognize this signal for the programmed time, avoiding notices of open
door when the alarm is armed.
* See Programming Table-
Disarm of the system using the reset button
In case you lose the transmitter, damage it or the battery of the same dies,
you can disarm the system by pressing the reset button.
First, with the security system armed, open the driver’s door and the siren will
start sounding.
Second, turn ON the ignition switch, before the 10 seconds press the reset
button the number of times assigned in the security code (1 as set by the
factory) the siren will continue to sound for 3 seconds and if the security code
is right the system will disarm.
PANIC
With this function, we can make the system to trigger intentionally to prevent or attract the
attention of people, in case of a theft or aggression attempt.
a. With the ignition in OFF,
- PANIC,
BUTTON 3
FOR 3 SECONDS
b. The siren and the lights will trigger for 3 seconds.
c. Press
button 1
or
button
2
to stop PANIC, the system will remain armed.
d. With the ignition in
ON.
Activate PANIC.
By stopping PANIC, the system will remain armed without the ignition interrupter, but if the
ignition key is turned to OFF position, the IGNITION INTERRUPTER will be activated.
CAR FINDER
With this function we can make the system to send us signals with the siren and lights,
which will serve us to locate the vehicle, whenever we are in the transmission range
between the remote control and the vehicle.
a. When the alarm is armed,
- CAR FINDER,
BUTTON
1 FOR 1 SECOND
b. The siren will chirp 10 times and the parking lights will flash 10 times.
c. Press
button 1
or
button 2
to stop the Car Finder.
