Genie Z45/25J, Operator'S Manual

Page: 26 / 38

24 Self-Propelled Servicing Platform Part No. 114047
Operator's Manual Second Edition • Fifth Printing
Introduction
This machine can be operated with or without the
engine running.
Starting the Engine
1 At the ground controls, turn the key switch to
the desired position.
2 Be sure both ground and platform control red
Emergency Stop buttons are pulled out to the
on position.
3 Be sure the engine lock-out switch is in the on
postion.
4 Move the engine start toggle switch
to either side. If the engine fails to
start or dies, the restart delay will
disable the start switch for 3
seconds.
If the engine fails to start after 15 seconds of
cranking, determine the cause and repair any
malfunction. Wait 60 seconds before trying to start
again.
Plug in the cold start package when needed. Be
sure to unplug before starting the engine.
In cold conditions, hold the glow plug switch to
either side and then start the engine.
In extreme cold conditions, 20°F / -6°C and below,
hold the glow plug switch to either side for 10
seconds and then start the engine.
OPERATING INSTRUCTIONS
Operating the Machine in
Hazardous Locations
Read, understand and obey the following
instructions before entering a Class 1, Division 2,
Group D hazardous location:
1 If the engine is running, turn off the engine.
2 Allow the engine to cool down until the
thermometer reads below 348°F.
3 Locate the engine and charger lock-out
switches.
4 Move the switches to the off position and lock.
5 Lock all 3 AC plug covers.
6 Be sure the lanyards on the battery disconnect
plugs are in place and secured.
7 Be sure the engine side chassis cover is latched
and locked.
8 Be sure the plate in the back of the battery box
is in place to prevent battery movement.