8
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
NOTE
The door must contact the 2” x 4” board before the
Carriage activates the Close Limit Switch . If not, readjust
the Close Limit Switch .
S
ettiNG
C
oNtaCt
R
eVeRSe
f
uNCtioN
Adjustment 2:
NOTE
Limit Switch and Force Adjustments must be completed
before checking the contact reverse function (Figure A-3) .
2” x 4” board
laid flat
Figure A-3 Checking Contact Reverse
A Open garage door using Wall Console .
B Lay a 2” x 4” board flat in center of doorway .
C
Close door using Wall Console .
D Check that door stops and reverses
within 2 seconds after it
contacts board:
•
If door does not reverse, decrease
Close Force until door reverses .
•
If door still does not reverse, move
CLOSE Limit Switch toward door .
E
Check Safe-T-Beam® System operation:
•
If beam is blocked, door will
not close .
Transmitter Compliance Statement
A To program one Button of a Remote Control (Figure MA-1):
•
Locate Learn Button and Learn Indicator Light
on back side of Power Head under the Lens
(Figure MA-2) .
•
Press and release Learn Button . Red Learn
Indicator Light will blink 2 times per second .
•
Press Remote Control Button once within 30
seconds . Red Learn Indicator Light will stay lit .
•
Press Remote Control Button again . Red Learn
Indicator Light will go out, indicating that
memory is stored .
B Program each additional Remote using step A above
(up to seven remotes) .
NOTE
• Each Remote Control must be programmed
separately .
• The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning .
• When programming the Remote Controls, they
must be at least 24” from the Antenna Wire .
• If the red Learn Indicator Light blinks
approximately 4 times per second,
programming has stopped . If programming
has stopped, repeat the above steps .
• Each Button on a 2 or 3 Button Remote Control
is for a different Opener . You cannot use more
than one Button per Remote, per Opener .
• A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time . If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see “To Erase All
Receiver Memory .”
C
p
RoGRammiNG
the
R
emote
C
oNtRolS
Programming 1:
a
CCeSSoRieS
WARNING:
A moving garage door may cause serious injury or
death .
• Keep people clear of opening while door is moving .
• Do not allow children to play with the Remote
Controls .
If the Safety Reverse does not work properly:
• Close the door and disconnect the Opener using
the Emergency Release Cord .
• Do not use the door Opener, Remote Controls, or
Wireless Keypad .
• Refer to the door and door Opener Owner’s
Manuals before attempting any repairs .
