Nov 00
Genicom
Publication No. GEG-99018A
GENICOM LN28 and microLaser 280 User Guide
4-15
Cleaning the Printer
4.
Verify that the power switch of the printer is in the [O] (off) position, then insert the plug of
the power cord into the AC outlet.
5.
Turn the printer on by pressing [ I ] on the power switch on the right side of the printer.
Cleaning the Interior
The interior of the printer does not generally need to be cleaned unless a paper jam drops toner
onto the paper path or you accidentally spill toner inside the printer when installing a new toner
cartridge. Use the following procedure to clean the interior of the printer only when necessary:
NOTE:
This procedure involves removing the toner cartridge. To avoid getting toner on counters,
floors, and other surfaces, set the toner cartridge on a drop-cloth or some old newspaper after
removing it from the printer.
SIB048F
1
2
Since there is always the possibility of damaging delicate printer components by careless-
ness or vigorous cleaning methods, GENICOM recommends that you clean the interior only
when you are instructed to do so by a service representative or in a troubleshooting proce-
dure presented in this manual.
Summary of Contents for LN28
Page 1: ...Nov 00 Genicom Publication No GEG 99018A GENICOM LN28 and microLaser 280 User Guide SIB012F...
Page 3: ...Nov 00 Genicom Publication No GEG 99018A GENICOM LN28 and microLaser 280 User Guide iii...
Page 4: ...Publication No GEG 99018A Genicom Nov 00 iv GENICOM LN28 and microLaser 280 User Guide...
Page 12: ...Publication No GEG 99018A Genicom Nov 00 xii GENICOM LN28 and microLaser 280 User Guide...
