Genesis React Pro, Owner'S Manual

Page: 72 / 88

72
RETURNING THE MODULE TO BOOT
• If the Boot was fitted with a Spacer and it was previously removed, replace the Spacer into
the Boot.
• Orient the Module over the opening in the Boot, and dip the bottom edge into it while
pressing the top edge with the palm of your hand. Stop pressing when the bottom edge of
the Module has just entered the Boot.
• Correct the alignment of the Module as needed so that it is straight.
• Press the Module completely into place with your thumbs, watching the alignment, until it
snaps into place.
R
E
S
P
O
N SIBLE
D
IV
E
R
NOTE: The Wet Activation Contacts are located on the stems of
the Buttons and on metal Pins located on the lower left side of the
module. The ReACT Pro module is designed for use in a Boot that
has an opening on the left side which exposes the Pins (and side
Wet Activation Contact) to water upon immersion.
WARNING: If the ReACT Pro is installed in a Boot that does not
have the side opening where the side Wet Activation Contact is
located, the unit may not activate automatically upon descending
on a dive.
N