Genesis React Pro, Owner'S Manual

Page: 22 / 88

22
ACTIVATION
PUSH BUTTON (PRIMARY METHOD)
To activate the ReACT Pro, press the RIGHT button once and release. It will immediately enter
Diagnostic Mode , displaying all “8’s” (Fig. 10), followed by “dashes”, and a countdown from 9
to 0. The left digit of the Main Time display and the lower Time display do not contain seg-
ments in their top/left positions.
While conducting diagnostics, the display is illuminated by the backlight as it checks its display
functions to ensure that everything is working properly and that battery voltage is sufficient to
complete a full day of diving. If there is not enough battery voltage, the unit will either deacti-
vate itself or would not have activated at all.
WARNING: If the Low Battery symbol (Fig. 10a) is still displayed following
diagnostics, Genesis Scuba strongly recommends that you DO NOT dive
until the battery is replaced.
When the button is held depressed as the Diagnostic countdown reaches 00, a Serial Number
screen appears displaying the unit’s firmware code Revision Number and Serial Number for as
long as the button is held depressed (Fig. 11). Upon releasing the button, the unit shuts Off.
The unit will automatically turn OFF 2 hours after activation if no dive is made. If the water ac-
tivation contacts are still bridged (the unit is wet), it automatically reactivates.
Fig. 11 - Serial Number
Fig. 10 - Diagnostic Mode
TAT TAT
OTL OTL
BT BT
AIR
MAX MAX M FT FT
STOP STOP
AM AM
PM PM
PO2 PO2
SAT SAT
2
O
NITROX
O
C
E
D
O
D
E
C
D
E
C
O
O
C
D
E
a
E
D