WALRUS 5000C
P a g e
| 12
Supplied mainly in vehicle kits, this standpipe is installed like so:
•
If possible, remove the sender unit from the vehicles fuel tank, this will make it easier to
attach the nut securely back onto the standpipe
•
Drill a Φ6 ± 0.2mm hole into the
sender unit
•
Remove the nut from the standpipe and feed it through the hole ensuring the rubber ‘o’ ring
remains on the standpipe ‘head’
side
•
Replace the nut on the standpipe to secure it safely to the sender unit.
•
Replace the sender unit into the fuel tank.
The bottom of the fuel standpipe should be 30-40mm from the bottom of the fuel tank to allow
enough suction of fuel and at the same time not allow impurities and sediment to be drawn up the
standpipe.
Summary of Contents for WALRUS 5000C
Page 13: ...WALRUS 5000C P a g e 13 WIRING DIAGRAM...
Page 19: ...WALRUS 5000C P a g e 19...
Page 20: ...WALRUS 5000C P a g e 20...
