Rev. 00 09/16
OptiFlex 2 F
Operation
25
Description
Presetting
Powder output
60 %
Total air
4.0 Nm³/h
High voltage
80 kV
Spray current
20 µA
Electrode rinsing air
0.1 Nm³/h
Fluidizing air
1.0 Nm³/h (for OptiFlex-F)
0.1 Nm³/h (for OptiFlex-B and S)
Setting powder output and powder cloud
The powder output depends on the selected powder output (in %), and
the powder cloud on the selected total air volume.
As a factory default value, a powder rate of 50% and a total air
volume of 4 Nm³/h are recommended.
– If values are entered that the gun control unit cannot implement,
then the operator is informed of this by a blinking in the relevant
display and a temporary error message!
Setting the electrode rinsing air
1.
Press the
key.
The second display level will be shown.
2.
Adjust the correct electrode rinsing air according to the applied
nozzles (deflector plate, flat jet nozzle)
≈ 0,1 Nm³/h
≈ 0,5 Nm³/h
too much electrode rinsing air
3.
If in this display level is no operation for 3 seconds, the first display
level is switched over independently.
Summary of Contents for OptiFlex 2 F
