GEM WK1, Owner'S Manual, Page: 75 / 105

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
66 Owner’s Manual
Recording a Program Change
You may decide to change a Sound during the recording. In that case
the Sequencer will record the corresponding Program Change number
to the relative track.
When playing the Style back , the track (or the tracks) containing the
Sound that has been changed, will play the first cycle of the Riff with
the original Sound and will change to the second Sound exactly as
recorded, that is, the second Sound will be included from the second
cycle and all the subsequent ones. It will not be possible therefore to
listen to the original sound, unless the Style is stopped and restarted.
To avoid this condition, it is advisable to record a Program Change to
the original Sound again, just before the end of the first cycle of the
Riff. In this way, all the successive cycles of the Riff will start with the
first Sound selected.
The best results are obtained when modifying Riffs that are 4 bars long
or more.
Recording Commands
All controls generated by hardware devices (Pedali, Pitch bend, Modu-
lation), or by the pedals connected to WK1 rear-panel sockets will be
recorded to the relative track. Attivate solo la traccia su cui desiderate
registrare i controlli.
To record Volume section messages, use the optional Volume Pedal,
that can be programmed in the Volume section in the General Menu.