![background image](http://html1.mh-extra.com/html/gehl/ge-802/ge-802_operators-manual_2205872026.webp)
PRINTED IN U.S.A.
3-8
90
8147
/0999
MACHINE OPERATION
Checklist Before Operation
Check the following items before each day of operation:
•
Seat belt and mounting hardware.
•
Decals. Replace as required.
•
Air cleaner and intake hoses.
•
Engine coolant level and system for leaks.
•
Clean engine area of any flammable materials.
•
Check engine oil level and fill if required.
•
Check hydraulic system for leaks and check hydraulic
fluid level.
•
Check all pivot points for proper operation.
•
Check track tension.
•
Check for broken and loose parts, and repair.
•
Check fuel tank.
IMPORTANT: Never operate machine until fuel tank
is completely empty. If this occurs, the fuel system
will have to be bled of air. Always fill tank after use.
Starting/Stopping the Engine
WARNING
Instructions are necessary before operating or
servicing the machine. Read this entire manu-
al and all decals on the machine. Follow all
warnings and instructions. Failure to follow all
instructions can cause injury or death.
WARNING
See the list of recommended lubricants in
Section 4–Maintenance for proper grade of
engine oil and hydraulic oil. Only use oils of
specified on the list or serious injury or death
could occur.
SAFETY DEVICES
When the machine is stationary (no pilot control pressure),
the parking and travelling gear brake are automatically acti-
vated.
All hydraulic functions are inoperable with the operator’s
seat left-hand console in the raised position.
The brakes are not released and hydraulic functions activated
until a travel lever or control lever is operated.
NORMAL STARTING/STOPPING PROCEDURE
1.
Adjust the operator’s seat to desired settings.
2.
Be sure all levers and controls are in neutral positions.
3.
Insert ignition key into switch and turn clockwise to the
first position. Indicators for oil pressure and battery
voltage will light.
4.
Turn the key fully clockwise and hold in position until
glow plug indicator goes out (approximately 10 seconds
when engine is cold).
5.
When engine starts, release the key.
6.
Allow engine to warm-up for approximately 5 minutes
to warm the hydraulic fluid.
7.
Turn the key fully counterclockwise to turn the engine
off.
IMPORTANT: Do not engage the starter motor for
longer than 10 seconds at each starting attempt. If
the engine does not start, wait 30 seconds, turn the
key fully off, then attempt to start the engine again.
WARNING
Do not use ether with glow plugs (preheat) sys-
tems. Explosion can result which can cause
injury or damage.
WARNING
When an engine is running in an enclosed
area, fresh air must be added to avoid concen-
tration of exhaust fumes. If the machine is sta-
tionary, vent the exhaust outside. Exhaust
fumes contain odorless, invisible gases which
can kill without warning.
Engines have hot parts and hot exhaust gas.
Keep flammable materials away from engine.
Do not use machine in atmosphere containing
explosive gas.
Summary of Contents for GE 802
