35
ASSEMBLY AND WIRING OF MAKEBOARD
Step 1
Take the end wire of each axis limit switch,
and insert it into the 2 pin connector (figure
10.1).
Figure 10.1
Step 2
Start assembly wiring with the effector
wires.
Loosen the through hole screws labeled
“heater” on the Makeboard and insert the
heater wires, securing the screws again
once in place (see figure 10.3)
Insert the fan wires into appropriate con
-
nectors on the Makeboard. Verify left and
right by tugging wires from the effector.
FanL corresponds to the cooling fan and
fanR corresponds to the radiating fan.
Complete the wiring of the effector by
inserting the thermH and autolevel limit
switch wire into their corresponding con
-
nections on the Makeboard.
The auto level limit switch will correspond
with the connector labeled “autolevel” on
the Makeboard.
Figure 10.2
Figure 10.3
Fan Left &
Fan Right
Auto level
(Limit switch)
Therm H
Heater
wires
Auto level
limit switch
Summary of Contents for Kinematics
Page 1: ...KINEMATICS 3D PRINTER MANUAL ...
Page 2: ......
Page 3: ...3 ...