7
ASSEMBLY OF THE TOP VORTEX
Step 1
Take a top vertex. The side having the hex
-
agonal groove in the center is on the bot
-
tom. (See figure 1.1).
Then attach M4*10 screws into the 4 holes
in the flank from the inside, As well as the
back hole of the Vertex .
After that, put on the M4 square nuts from
the outside (attention: only turning nut ap
-
proximately 3 times, they should be loose.)
(As figure 1.2)
Repeat this step for the remaining vertexes.
Figure 1.1
Figure 1.2
Materials needed for assembly
Short V rails (3)
Top vertex (3)
M4 Square nut (12)
M4*10 screw (12)
This filler head
is at the top
Hexagonal groove
side at bottom
1
2
3
4
Summary of Contents for Kinematics
Page 1: ...KINEMATICS 3D PRINTER MANUAL ...
Page 2: ......
Page 3: ...3 ...
