18
Step 5
Secure
Slide the linear rails onto the long V rail
grooves, securing them temporarily while
we attach the limit switch in place.
Secure the limit switch 5cm below the top
of the open beam groove using a M4 nut if
the original M4T nut is not fully securing the
limit switch in place. (see figure 3.8)
Slide the linear rails up, securing them right
below the limit switch (See figure 3.9).
Figure 3.9
Figure 3.8
Figure 3.10
Summary of Contents for Kinematics
Page 1: ...KINEMATICS 3D PRINTER MANUAL ...
Page 2: ......
Page 3: ...3 ...
