GEA ONE 11TS, Instructions For Use And Maintenance Manual

Page: 98 / 301

ONE 7TS – Operation and use
ATTENTION:
Pressure adjustment must be made FIRST on the 2nd stage, applying the desired value, and THEN
on the 1st stage to reach the total pressure required.
Using a different operating sequence involves SERIOUS RISKS because it can inadvertently bring
the machine to pressure levels exceeding the values for which the machine is designed.
The adjustment operations are:
•
check that the pressure reducer (B , D) is completely loosened
•
rotate the reducer knob of the second stage (D) , rotate it to obtain the required homogenization pres-
sure; check value with pressure gauge.
•
pull the pneumatic switch of the first stage (A) to the ON position;
•
rotate the reducer knob of the first stage (B) to obtain the required homogenization pressure; check
value with pressure gauge.
ATTENTION:
The pneumatic adjustment system is designed with a degree of inertia to enable slow, gradual pres-
sure increase.
Adjust the pressure knob slowly checking the actual increase of homogenization pressure up to the
work value.
Once the homogenization pressure has been set to the required value you can block the reducer knob (B) by
pressing it..
If the pressure entered is normally used in production, you can connect and disconnect pressure by acting
ONLY on the pneumatic selector switch
(A) , leaving the reducer blocked in the adjusted position
.
pag 6.12
Il presente manuale è di proprietà GEA Niro Soavi S.p.A. ogni riproduzione, anche parziale, è vietata.