GEA ONE 11TS, Instructions For Use And Maintenance Manual

Page: 8 / 301

ONE 7TS – General Information
page 1.6
This manual is property of GEA Niro Soavi S.p.A. and no part of it may be reproduced.
1.3.1.3 Exclusions and limitations
The warranty shall not cover materials and parts that are subject to normal wear such as, for example, all the
gaskets used on the machine, transmission belts, plunger gaskets and associated anti-extrusion washers
and support washers, safety valve seat, filters, etc., and the parts whose lifetime cannot be determined be-
forehand, such as lamps, fuses, plunger pistons and their coating, plunger valves and their seats, homoge-
nizing valve, pressure gauges.
For components and accessories purchased from external suppliers,
GEA Niro Soavi S.p.A shall apply to
the Customer the same warranty conditions granted to them by the manufacturer.
1.3.1.4 Returned material
Before returning to
GEA Niro Soavi S.p.A.
the parts for which you request replacement or repairing under
warranty, you must send a written notice to the Spare Parts Department for approval.
The parts must be properly packaged to prevent damage during transport and they must be accompanied
by:
-
reference to purchase order;
- serial number of machine;
- spare part code number;
- accurate description of fault and of the way in which it occurred.
The parts accepted in warranty are delivered ex-origin; the parts replaced become the property of
GEA Niro
Soavi S.p.A. and must be delivered ex your factory .
1.3.2 General test
This machine has been accurately inspected in the premises of GEA Niro Soavi S.p.A. before shipment,
with operating test simulating normal working conditions.
The test was performed with cold water to verify match between machine characteristics and design charac-
teristics, calibration of safety, regulation and control systems, efficiency of seals and general operation with
no abnormal noise or vibrations, parametrization of any instruments or programmable equipment.
Testing of machine performance (flow rate at the maximum operating pressure, noise level, power absorp-
tion) was carried out with water at 20 °C approx., so it was possible to verify that the deviation of actual ma-
chine flow rate with respect to the rated value is ± 5% depending on the different temperatures and viscosity
values of the product treated.
After installation, at the time of startup, it is still necessary to run a final general test on site with the presence
of technicians from
GEA Niro Soavi S.p.A