7.
Examine shaft again for burrs and remove them if necessary.
8.
Lightly grease the surface with Klüber paste and install the seal (see
operating manual).
→ The shaft protection sleeve has been installed.
B
A
C
D
Fig.20:
Drive the sleeve with light blows from the mallet onto the shaft.
A - Hammer, B - Mounting sleeve, C - Shaft protection sleeve, D - Shaft
Removing the shaft protection sleeve
If necessary, the shaft protection sleeve can be removed from the shaft in various
ways.
–
In most cases, it can be pulled easily pulled from the shaft by heating the
sleeve.
–
The predetermined tear line can be overcome towards the sleeve using a
jerky movement of a side cutter.
–
By light blows with the mallet peen across the width of the sleeve, it widens
and can be removed easily.
→ The shaft protection sleeve has been removed.
Malfunctions / repairs
Repair
BA.H2A.KYY.001.GB_2
27.02.2018
53
