GE Vivid S60N, Basic Service Manual

Page: 112 / 478

D
IRECTION
FR091521, R
EVISION
1 V
IVID
S60N/V
IVID
S70N B
ASIC
S
ERVICE
M
ANUAL
3-24 Section 3-5 - Completing the Setup
P R E L I M I N A R Y
Follow these steps to connect a probe:
1) Before connecting the probe:
a.) Do a visual check of the probe pins and system sockets.
b.) Remove any dust or foam rests from the probe pins.
c.) Verify the probe and the probe cable for any visual damage.
2) Hold the probe connector vertically with the cable pointing upward.
3) Turn the connector locking handle counter-clockwise to the horizontal position.
4) Align the connector with the probe port and carefully push into place.
5) Turn the locking handle clockwise to the full vertical position to lock in place.
6) Position the probe cable so that it is not resting on the floor.
3-5-6-3 Disconnect Probes
Follow these steps to disconnect probes, as applicable:
• DLP Probes
1) Rotate the lock handle counter-clockwise to the horizontal position to unlock the connector.
2) Carefully remove the connector from the port.
3) Ensure that the probe head is clean before placing the probe in its storage case.
For cleaning instructions, see the User Manual .
• RS Probes
1) Move the connector locking lever to the left to unlock the connector.
2) Carefully remove the connector from the port.
3) Ensure that the probe head is clean before placing the probe in its storage case.
For cleaning instructions, see the User Manual .
• Pencil Probes
1) Pull the release sleeve (located on the probe connector) backwards to unlock and release the
probe.
2) Carefully remove the connector from the port.
3) Ensure that the probe head is clean before placing the probe in its storage case.
For cleaning instructions, see the User Manual .
3-5-7 Power on/Boot up
For procedure, see: Power ON/Boot-up on page 4 - 3 .
3-5-8 Power Shut Down
For procedure, see: Power Shut Down on page 4 - 7 .
3-5-9 Complete Power Down
For procedure, see: Complete Power Down on page 3 - 24.