NX-1710E Single Door Control
4
I.
GENERAL DESCRIPTION
The NetworX NX-1710E is a single door control module used to expand the capabilities of the NetworX control
panels.
•
Flash-based microprocessor for reprogramming ability via In-Circuit Serial Programming
™
header
•
+5 VDC and +12 VDC outputs
•
4-position dip switch which allows addressing of up to 16 modules on the NetworX bus
•
Box tamper switch tied to tamper terminal
•
One zone input to be connected to a door contact for monitoring the door zone.
•
On-board relay with Normally Open, Normally Closed, and Common terminals for use in switching
power on MagLocks or other door locking mechanisms
•
8Kb of non-volatile RAM for storing programming and card data
•
Two sets of terminal inputs/outputs for interfacing with one or two Wiegand card readers:
o
1 buzzer and 2 LED outputs
o
1 tamper and 1 egress input
o
2-wire Wiegand bus interface.
Readers must be able to “speak” Wiegand. The
following are supported Weigand formats by default:
26-bit standard Weigand
27-bit Tecom ASC
35-bit HID Corporate 1000
37-bit HID 10304
40-bit with facility code (Casi Rusco 4001)
40-bit without facility code (Casi Rusco 4002)
