Griddle Module
See Griddle Cooking Guide.
Your non-stick coated griddle
provides an extra-large cooking
surface for meats, pancakes or
other foods usually prepared in a
frying pan or electric skillet.
You can also use the griddle as a
warming tray by using a
heat setting. Because the heating
element under the griddle is
divided, you can vary the
temperature on the front and
rear sections.
How to Assemble the
Griddle Module
Step 1: Be sure the controls are
OFF.
Step 2: Place the two reflector
plates in the grease well.
Step 3: Grasp the grill element
with both hands near the plug.
Keeping the element as nearly
horizontal as possible, push the
plug firmly into the receptacle to
ensure complete contact.
Step 4: Place the griddle into the
opening in the cooktop with the
two drain holes toward the front
of the cooktop (nearest the
controls). See illustration.
NOTE: When properly placed, the
griddle sits slightly above the
cooktop. This, and the open spaces
on the sides and rear of the griddle,
prevent excessive temperatures.
Using the Griddle
The non-stick griddle must
be preconditioned before
using it for the first time. To
precondition, first wash the
griddle in soap and water and
dry. Then use a paper towel to
apply a small amount of
cooking oil to the griddle.
Remove excess oil with a clean
paper towel.
Grill Element.
Two Reflector<
Plates
. .
Preheat the griddle as
How to Remove
recommended in the Griddle
Griddle Module
Cooking Guide. After preheating
for the recommended amount of
Be sure the controls are OFF and
time, apply a small amount of oil
or butter.
Do not overheat the griddle.
Leaving the griddle at HI for
more than 10 minutes without
food can damage the non-stick
coating.
When using the griddle, a low vent
system setting is recommended.
the griddle is cool.
To remove the griddle:
Step 1: Lift the back edge of the
griddle a bit to let any excess fat or
oil drain.
Step 2: Remove the griddle.
Step 3: Grasp the element with
both hands on either side of the
plug.
Step 4: Raise the opposite side of
the element just enough to clear
the well, then pull away from the
receptacle. The element will not
sit level when replaced if it is
forced too far upward when
removed.
Step 5: Remove the two reflector
plates.
20
