34
Incandescent Drum Lamp
Incandescent Drum Lamp Strip Circuit
N
L1
To Belt Switch
and Steam Valve
High Limit
Thermostat
Door Switch
Drum Lamp
To MCB J1-3
(Door Sense)
Terminal
Block
On Some Models
Operating Voltage: 120 VAC
Incandescent drum lamps are not present on all
models, some models have LED drum lamps.
Incandescent Drum Lamp Removal
1. Disconnect power from the unit.
2. Remove the control panel.
3. Remove the front panel.
4. Remove the front con-
trol assembly bracket assembly.
5. Remove the bulb, then squeeze the lamp mount-
ing clips and pull the lamp socket out through
the inside of the drum.
Front Drum Support
Front Drum Support Removal
1. Disconnect power from the unit.
2.
5HPRYHWKHOLQW¿OWHU
3. Remove the control panel.
4. Remove the front panel.
5. Remove the trap duct.
6. Remove the front con-
trol assembly bracket assembly.
7. Disconnect the wires connected to the front
drum support.
Harness Connector
8. Remove the four 1/4 in. hex screws that secure
the front drum support to the side panels.
9. Lift front drum support out of the key holes.
Bulb
Socket
See Drum Lamp Location on page 17.
See LED Drum Lamp Section on page 33.
See Control Panel Removal on page 20.
See Front Panel Removal on page 24.
See Front Control Assembly Bracket Removal
on page 25.
See Control Panel Removal on page 20.
See Front Panel Removal on page 24.
See Trap Duct Removal on page 38.
See Front Control Assembly Bracket Removal
on page 25.
