CAUTIONS (continued)
CAUTION:
The available power source con-
nected to the Drive
IS
not to exceed 500KVA. If the
ac power source is greater than
and the
rated (HP)
IS
less than 10% of the power
source’s KVA; ac
reactors will have to be
installed
L2 L3 power leads of the
CAUTION:
The Drive must be mounted on a
building or enclosure wall that
IS
constructed of
heat resistant material. While the Drive
IS
operat-
ing, the temperature of the Drive’s
can
rise to a temperature of 90°C (194°F.)
CAUTION:
If the Drive protective
IS
activated, consult Section 8 “Troubleshooting”, and
aftercorrectingthe problem,
not reset the alarm
external
auence, etc
CAUTION:
Be sure to provide fuses, as specified
on “Application of Wiring And Equipment”
Section 4, on line
of Drive Provide power
or contactor as needed
NOTES
NOTE:
When terminal
mode (Function code
F-02 setting
IS
1) RUN and STOP are
controlled by a
contact (e.g., selector
toggle
etc.) which
IS
connected
between the terminal CM and FWD or REV
l
the maintained contact starts/
stops the Drive.
Total
between the
and the motor must
not exceed the length shown below
230V
460V
data
H
P
754
Function code F-02 setting can be changed only
when connection between the terminals CM and
FWD or REV
IS
open.
(
I
e. STOP MODE).
Error in current detection may increase when;
a) A specially designed motor
IS
used
b) A Drive’scapacity is 2 Hp ratings or greaterthan
the motor capacity.
Drive Caution Label
Use
copper wire only. Use Class
wire only.
Suitable for use on a circuit capable or delivering not more than 1,000
(1 Hp or less) or 5,000 (2 Hp or more) rms symmetrical amperes, 230V
maximum.
WARNING:
H A Z A R D O F E L E C T R I C A L S H O C K . D I S C O N N E C T I N C O M I N G
POWER BEFORE WORKING ON THIS CONTROL.
ADVERTISSEMENT:
RISQUE DE CHOC
COUPER
L’ALIMENTATION AVANT LE DEPANNAGE DE CETTE COMMANDE.
CAUTION:
DANGEROUS VOLTAGE EXIST UNTIL CHARGE LIGHT IS OFF.
ATTENTION:
PRESENCE DE TENSIONS DANGEREUSES TANT QUE LE
VOYANT N’EST PAS
WARNING: MORE THAN ONE LIVE CIRCUIT. SEE DIAGRAM *
AVERTISSEMENT:
CET
RENFERME
CIRCUITS
TENSION.
LE SCHEMA.
*See diagram on page
4-6
of the
AF-300
Drive
manual
1-4
Summary of Contents for Fuji Electric MICRO-SAVER AF-300
