GE Fuji Electric MICRO-SAVER AF-300, Instructions Manual

Page: 34 / 78

Section 5
D R I V E
I
PRE-OPERATION INSPECTION
After mounting and has been completed, check the for the following before AC power:
Check for wiring errors.
Verify that there are no wiring chips, screws, etc. remaining
the Drive.
Check that all screw and terminal connections are tight.
that no exposed ends are touching other
KEYPAD PANEL IDENTIFICATION /OPERATION
See the diagrams for Display and Keypad Operation description when the Mode, Program
Mode or Mode
FUNCTION CODE AND DATA CODE DESCRIPTION/SELECTION
When AC power is applied to the the keypad panel be as shown 5-1 and be
flashing on and off. If the RUN key IS pressed at point, be at 60 Hertz according to the
Function Code set at the factory. (Use key to halt operation )
-- A Flashing display indicates the set frequency when a run command is not present.
-- A Solid display
the actual output frequency when the
IS
If a test run is desired, press the key to change the flashing display of 60.00 Hz frequency setting to
5.00 Hz. Press Run to conduct the test run and check for smooth motor operation and direction of rotation.
Removal of AC power when a keypad setting is made
set in the memory.
PANEL
C O N T R O L
Figure 5-l. KEYPAD PANEL DISPLAY WHEN AC POWER IS APPLIED