GE Dash Port 2, Service Manual

Page: 71 / 108

Revision A Dash Port 2 Docking Station 5-13
2000966-138
Troubleshooting: Troubleshooting Procedures
The monitor pivots when the security lever
is in the lock position. The docking station’s locking mechanism
may have been accidentally activated
before the monitor was placed on the
docking station. 1. Remove the monitor.
2. Re-set the locking mechanism by
moving the security lever to the unlock
(far right) position.
3. Reposition the monitor.
The monitor might not be positioned
correctly on the docking station to allow all
four clamps to secure the monitor’s GCX
plate. 1. Remove and re-position the monitor on
the docking station.
2. Verify the monitor doesn’t pivot.
The Top Assembly FRU has failed. “Replace the Top Housing FRU” on
page 6-18.
The docking station will not release the
monitor when the security lever is moved to
the unlock position. The security lever was not moved and held
in the unlock position while the monitor was
removed. Slide and hold the security lever in the
unlock (far right) position until you remove
the monitor from the docking station.
The Top Assembly FRU has failed. 1. Remove the six screws from the bottom
of the docking station to separate the top
housing of the docking station from the
bottom housing of the docking station.
2. Use a bladed screw driver to manually
release the docking station’s clamps
from the base of the monitor.
3. If necessary, contact Technical Support.
4. “Replace the Top Housing FRU” on
page 6-18.
The security lever doesn’t move to the far
left position. Cables or other objects may be blocking
the monitor’s AC power or communication
ports. 1. Remove the monitor from the docking
station.
2. Remove any cables or other objects
from the connector ports located on the
bottom of the monitor.
3. Reposition the monitor.
The monitor’s expansion PCB may be
damaged. Replace the monitor’s damaged expansion
PCB. See the Dash Patient Monitor’s
Service Manual.
The monitor may not be positioned
correctly on the docking station. Remove and reposition the monitor.
Foreign objects may be blocking the
monitor’s expansion PCB. 1. Remove foreign objects blocking the
expansion PCB.
2. Reposition the monitor.
The Connector Assembly FRU has failed. See, “Replace the Connector Assembly
FRU or PCB FRU” on page 6-19.
Problems and Solutions Table
Problem Cause Solution