GE Dash Port 2, Service Manual

Page: 53 / 108

Revision A Dash Port 2 Docking Station 4-13
2000966-138
Maintenance: Checkout Procedures
Checkout Procedures
Manufacturer Recommendations
Frequency
127(
Complete the checkout procedures with a Dash monitor connected to
the docking station.
GE recommends that you perform checkout procedures:
„
upon receipt of the device.
„ every twelve months thereafter, and
„
each time the main enclosure is disassembled or a circuit board is
removed, tested, or replaced.
127(
To troubleshoot operation problems, see Chapter 5,
“Troubleshooting” .
Test Equipment
The following table lists GE recommended test equipment, adaptors, and
cables you need to successfully complete the checkout procedures. The
checkout procedures are written for the test equipment in the following
table. If you use test equipment other than those GE recommends, you
may need to slightly modify some test steps.
Patient Simulators and Cables
ECG Test
„ Marq-I ECG Simulator (no longer available for ordering)
„ MarqII-KIT (includes CO injectate box)
„ MarqIII-KIT (includes CO injectate box)
127(
You can use a MarqI, MarqII, or MarqIII patient simulator or an
equivalent 12SL ECG patient simulator.
„ ECG Patient Cable
„ ECG Leadwire Set
„ Remote control, PN 418720-xxx, with an autoport to Mport adapter, PN 2001973-001
Auxiliary Test
„ Remote control, PN 418720-xxx, with an autoport to Mport adapter, PN 2001973-001