Installation Instructions
IMPORTANT:
these instructions with the appliance.
OWNER: Keep these instructions for future use.
Tools Needed
For window installation
For through-the-wall installation
●
Blade-type screwdriver
●
All the tools at left (except knife)
●
Rule or tape measure
plus
●
3/8” pipe tap
●
Magnetic stud finder (optional)
●
Hex driver
●
Knife
. Tin snips (optional)
●
Level
●
Drill
●
Caulking gun
●
Hammer
●
Hand saw
●
Chisel
●
Concrete saw (if installing
through a masonry
Screws
Type A
Electrical Safety—
IMPORTANT...
Read
How to connect electricity
For personal safety,
appliance must be properly
grounded.
Electrical requirement
models require a 115/120
volt
60
grounded
protected with a 15 amp time delay
fuse or circuit breaker.
The power cord of this appliance
is equipped with a three-prong
(grounding) plug which mates with
a standard three-prong (grounding)
wall outlet (Fig. 1) to minimize the
possibility of electric shock hazard
from this appliance.
PREFERRED
METHOD
.
A\
INSURE PROPER
Fig. 1
BEFORE USE
Have the wall outlet and circuit
checked by a qualified electrician
to make sure the outlet is properly
grounded.
Where a standard two-prong
wall outlet is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall outlet.
Type B
DO NOT, UNDER ANY
CAUTION: Attaching adapter
CIRCUMSTANCES, CUT
ground terminal to wall outlet cover
OR REMOVE THE THIRD
screw does not ground appliance
(GROUND) PRONG
unless cover screw is metal, and
THE POWER CORD.
not insulated, and wall outlet is
through house wiring. You
have
checked by a
qualified electrician to make sure
Use of adapter plug
the outlet is properly grounded.
Because of potential safety
When disconnecting the power
hazards under certain conditions,
cord from the adapter, always
we strongly recommend against
hold the adapter with one hand. If
the use of an adapter plug.
this is not done, the adapter ground
However, if you still elect to use an
terminal is very likely to break with
where local codes
repeated use.
a T;
-
may be made to a properly grounded
Should the adapter ground
terminal break, DO
USE the
two-prong wall outlet by use of a
listed adapter (Fig. 2) available
at most local hardware stores.
TEMPORARY METHOD
(ADAHER PLUGS
IN
‘-
ALIGN LARGE
The larger slot in the adapter must
be aligned with the larger slot in
the wall outlet to provide proper
polarity in the connection of the
power cord.
7
appliance until a proper ground
has again been established.
Use of
cords
not recommended
Because of potential safety
hazards under certain conditions,
we strongly recommend against
the use of an extension cord.
However, if you still elect to use
an extension cord, it is absolutely
necessary that it be a
listed
3-wire grounding type appliance
extension cord having a grounding
type plug and outlet and that the
electrical rating of the cord be 15
amperes (minimum) and 120 volts.
(continued next page)
