6
49-7819
USING THE
A
IR CONDITIONER
Controls
Cool Mode
Use the COOL mode for cooling.
To set the COOL mode:
1. Press the
MODE
pad until the
COOL
indicator light is
lit.
2. Press the
FAN
pad to set HIGH, LOW, or SLEEP fan
speed.
3. Press
+ or -
to set the desired temperature between
61°F and 89°F in 1°F increments.
After settings have been made, the display will change
back to show the room temperature.
The temperature control is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
temperature control at a lower number and the indoor
air will become cooler. Set the temperature control at a
higher number and the indoor air will become warmer.
NOTE:
If the air conditioner is off and is then turned on
while set to COOL, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Cooling Descriptions
For Normal Cooling
—Select the COOL mode
and HIGH or MEDIUM fan speed with a middle set
temperature.
For Maximum Cooling
—Select the COOL mode
and HIGH fan speed with a lower set temperature.
For Quieter & Nighttime Cooling
—Select the
COOL mode and LOW fan speed with a middle set
temperature.
NOTE:
If you switch from COOL or DRY mode setting to
OFF wait 3 minutes before restarting.
DRY Mode—Dehumidification
Use the DRY mode to provide dehumidification only.
The fan will run at a fixed speed at this setting, so a fan
speed cannot be set. Keep windows and doors closed
for the best dehumidifying effects.
To set the DRY mode:
•Press the
MODE
pad until the DRY indicator light is lit.
In the DRY mode, a set temperature will not be
displayed. After DRY mode has been set, the display will
change back to show the room temperature.
NOTE:
If you switch from a DRY setting to OFF or to a
fan setting, wait at least 3 minutes before switching back
to a DRY setting.
If using the unit in the DRY mode as a dehumidifier for
an extended time.
1 . Unplug the power cord.
2. Connect a drain hose (not included) to the center
drain port (see page 9, upper drain #8) and lead hose
to floor drain.
3. Reconnect the power cord and press the MODE pad
until the DRY indicator light is lit.
FAN Mode
Use the FAN mode to provide air circulation and filtering
without cooling.
To set the FAN mode:
• Press the FAN pad until the desired indicator light for
HIGH, LOW, or SLEEP fan speed is lit.
Since fan only settings do not provide cooling, a set
temperature will not be displayed. After FAN speed has
been set, the display will change back to show the room
temperature.
Power Outage Recovery Feature
In the case of a power outage or interruption, the unit will
automatically re-start in the settings last used after the
power is restored.
NOTE: If the TIMER was set before the power outage, it
will need to be reset after power is restored.
The display will always default to show the room temperature.
When the air conditioner is turned on, it will automatically start in the last mode and fan settings selected.
Summary of Contents for APCA10NXMGN1
Page 14: ...14 49 7819 Notes NOTES...
Page 30: ...14 49 7819 Notas NOTAS...
