– 11 –
Freezer Drawer Front
The freezer drawer front is inserted into alignment
slots (1 on each side) and attached to the slide
assemblies with 6 bolts (3 on each side).
To remove the freezer drawer:
1. Remove the freezer drawer, bin, and basket. (See
Freezer Drawer, Bin, and Basket
.)
2. Remove the six 3/8-in. hex-head bolts (3 on
each side) that attach the drawer front to the
slide assemblies.
3. Lift the drawer front from the slide assemblies.
L
I
F
T
4. Place the drawer front on a protected surface.
Note:
• When installing the freezer drawer front, make
sure the drawer alignment tabs are placed
inside the alignment slots before installing the
six 3/8-in. hex-head bolts.
• An adjustment knob is provided on each side
of the freezer drawer front to change the
horizontal drawer position.
Knob
Slot
Tab
After installation of the freezer drawer front, check
for uniform gaps (top and bottom of right and left
hand side). Gap should be 0.6 inches.
To adjust the freezer drawer front gaps:
Caution:
The 6 mounting screws (3 on each side) are
NOT interchangeable with the center or top hinge
screws.
1. Loosen the six 3/8-in. hex-head bolts (3 on each
side) that attach the drawer front to the slide
assemblies.
2. Adjust the 3/32-in. Allen set screw clockwise if
gap at the top is too big.
3. Adjust the set screw counterclockwise if gap at
the bottom is too big.
4. Tighten the 3 screws on each side (right and left).
5. Re-check the gaps and repeat steps 1 to 4 if
required.
Set Screw
