Getting started
Getting started
6
7
If both of your telephone lines are located in one wall jack, go to step 4. If your
telephone lines are in two separate jacks, go to step 8.
4. Route the 4-pin telephone line cord from the
Line 1 + Line 2
jack through the
channel as shown in Figure 8, leaving about 2 inches from the end of the channel
for plugging into the wall jack.
desk
wall
desk
wall
Figure 7
3. Slide the wall mounting switch to the wall position as shown in Figure 7. This
prevents the handset from falling out of the telephone base.
desk
wall
Figure 8
5. Plug the telephone line cord into the 2-line wall jack on the wall plate as shown
in Figure 9. Align the holes on the telephone with the mounting studs of the wall
plate and slide the telephone base down until it locks securely. Tie the excess cords
neatly with a twist tie. Plug the power adapter into an electrical outlet. Be sure to
avoid using an electrical outlet that is controlled by a wall switch.
desk
wall
Figure 9
6. Press
or
as desired. The speakerphone is activated automatically.
7. If you hear a dial tone, the installation is complete.
