Changing modes while system armed (optional)
Double pressing the
[
AWAY
],
[
STAY
], or
[
NIGHT
] key will change to the corresponding mode. Once the
AWAY
mode is entered, the system must be disarmed to change modes.
IMPORTANT!
The
instant message
needs to be off if you plan on re-entering the building, otherwise you will create an alarm.
You may re-initiate an entry/exit delay by pressing the
[STAY] key again. The
instant message
will go out.
Disarming the system
When you enter the protected area through one of the designated Entry/Exit doors, the keypad control will sound a
continuous tone for the duration of the entry delay time, or until you enter a
valid code.
Type code to
Disarm
•
Enter a valid user code.
•
The currently armed key
[
AWAY
],
[
STAY
],
or
[
NIGHT
] will go off and the tone will stop. The security system is now DISARMED. If a valid
code is not entered before the end of the entry delay, an alarm will occur.
NOTE:
If the
[AWAY],
[STAY], or
[NIGHT] keys are all flashing during the entry delay, the alarm system
has been activated in your absence. Leave the building immediately and call your alarm company and/or the
police from a safe location.
CANCEL / ABORT feature (optional)
Entering a user code during an alarm report to the central station will stop the communication of all abortable
reports.
NOTE: The abort feature must be enabled
.
Entering a user code after an alarm report to the central station will send an appending report to the central station
after the cancel report.
NOTE: The cancel feature must be enabled
NX-1248E User manual
Page 10
16/04/05
