GCC Technologies P3-60, User Manual

Page: 52 / 179

Puma III User Manual
The Control Panel 3-4
Save parameter
Select: OK:ENTER
[TOOL SELECT ]
1S:51 F:80 O:0.275 M
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Restore default
Select: OK:ENTER
OverCut:0.00-1.00mm with an
increment of 0.05mm
Offline For
System Setup
Enable, Disable
Auto Unrolled Media
Select: OK:ENTER
Vacuum
Select: OK:ENTER
[
MISC
]
Image Scale Width
Select: OK:ENTER
Paper Saving Mode
Select: OK:ENTER
English, Chinese
Select Unit
Select: OK:ENTER
Both Expanded Mode
、
Length Expanded Mode
、
Width Expanded Mode
、
Both Unexpanded Mode
Set Communication
Select: OK:ENTER
Firmware
：
x.x.xx
FPGA
：
Vx.x mm/dd/yy
AAS Offset
Select: OK:ENTER
Metric (cm/gram) or English measurement (inch/oz)
or Unit (cm/oz) or Unit (inch/gram)
Image Scale Length
Select: OK:ENTER
Scale Length
Select: OK:ENTER
Scale Width
Select: OK:ENTER
First back to origin
Select: OK:ENTER
Select Language
Select: OK:ENTER
Rear Paper Sensor
Select: OK:ENTER
Enable, Disable