GCC Technologies P3-60, User Manual

Page: 12 / 179

Puma III User Manual
Installation 2-1
Chapter 2 Installation
2.1 Precaution
Notice 1

Carefully handle the cutter to prevent any injuries.

Make sure the power switch is off before installing the cutting plotter.
Notice 2 A proper place for installation the cutting plotter
Please select a proper location that meets the following conditions.

The machine can be approached easily from any direction.

Keep at least 60 cm space in front and behind the machine.

Make sure the cutter is placed on a flat, level and sturdy surface

The operation temperature should be between 15 and 30
℃
(60-86
o
F) in the
workshop.

Keep the relative humidity between 25% and 75% in the workshop.

Protecting the machine from dust and air current.

Preventing the machine from direct sunlight.
Notice 3 Connecting the Power Supply
Check the plug of the power cord to see if it matches the wall outlet. If not, please
contact your dealer.

Insert the plug (male) into a grounded power outlet.

Insert the other end (female) of power cord into the AC connector of cutting
plotter.