gc Labolight DUO, Instructions For Use Manual

Page: 25 / 176

6.2.2 Method of removing/remounting the Step mode switch cover
< Removal method >
12
10
7
9
8
11
With the turntable removed, remove the cover by hooking the notches
thereof on your fi ngers.
< Mounting method >
12
10
7
9
8
11
Align the protrusion of the step mode switch cover with the hole of the
step mode switch plate and insert the protrusion into the hole.
* Going over the plate circumference with the cover protrusion makes
the work easy before pressing the protrusion into the hole.
6.2.3 Method of replacing the lens cover
< Preparation >
2 5
12
17
1) Turn off power and pull out the AC adapter.
2) Remove the turntable and lay the main body laterally.
< Removal method >
3) Insert your fi ngernail or tweezers into the clearance formed [A] between the lens holder and the lens cover
through the concave on the holder, and then slide the cover toward the concave [A].
17
16 15
13
14
Lens cover holder
C
B
A
Lens cover
E
D
EN
EN 23
CAUTION
■
Turn off the main switch and plug off the power cord prior to cleaning or parts replacement.
6.2.1 Cleaning method of respective portions
CAUTION
■
Be sure to clean the curing chamber regularly, as otherwise, the contaminated chamber could not exercise
suffi cient curing performance.
Contents Details
Lens cover
Wipe off with a soft cloth wetted with a small amount of water or alcohol.
* In case of any discoloration, contamination or scratches cannot be cleaned, replace the lens cover.
* Lens cover potentially be discolored by aging.
CAUTION
■
Clean off contamination of the lens cover or replace the contaminated cover. Otherwise, the
contaminated portion is heated to cause deformation or melting of the cover.
■
If the unit is used without the lens cover mounted, the performance could be deteriorated due
to insufficient protection of the lens. Be sure to use the unit with the cover mounted.
Turntable
Wipe off with a soft cloth wetted with a small amount of water or alcohol.
* Pull up the turntable for removal.
* When remounting the turntable, rotate it to find one of the six positions (provided at an interval of
60 degrees) where the turntable enters deeply into the bottom.
Step mode switch
Wipe off with a soft cloth wetted with a small
amount of water or alcohol.
For dirt accumulated in a clearance, remove the
step mode switch cover and clean by using a
cotton swab, for example.
(for removal method, see Item 6.2.3)
Visor Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
Housing, Curing
Chamber
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
Curing stand
holder
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
Tray
Metal post
Clip
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
* Disinfection with chemical solution allowed.
* Autoclave sterilization possible
Curing plate
Curing stand
Silicone post
Wipe off with a soft cloth wetted with a small amount of water or alcohol, in principle.
* Disinfection with chemical solution allowed.
* Autoclave sterilization possible (However, repetitive operation causes deterioration.)
Note
●
For cleaning the unit, use a soft cloth wetted with a small amount of water or alcohol. In addition, do not
use organic solvent (thinner, benzine, etc.).
●
Care should be taken for the unit being possibly whitened in the portion where organic solvent attaches.
Immediately wipe off such a solvent if attached.
EN 22