GBR Systems M-40, Operator'S And Service Manual

Page: 153 / 161

M-40 OPERATOR & SERVICE MANUAL ISSUE 05/01 ADJUSTMENTS
SECTION D – PAGE 6
D.2 FOLDER
D.2a Folder Plates
How the folds are made
1. Fold Rollers 1 and 2 transport the document sheet into the Fold Plate,
which has an Adjustable Stop.
2. When the sheet comes up against the stop, a buckle is formed as the
rollers continue to turn.
3. As the buckle, or loop, enlarges, Fold Rollers 2 and 3 seize the loop and
create the fold.
4. The next set of rollers transport the document sheet into the following Fold
Plate or past a Bypass Plate.
5. The process continues through all fold rollers.
Fold Plate Operation
Adjusting the Fold Plate
1. Remove the Fold Plate as illustrated below.
2. Place the Fold Plate onto a table or secure flat surface.
3. Loosen the Knurled Knob securing the Adjustable Stop.
4. Set the Adjustable Stop to the desired measurement using the scale.
5. If necessary, adjust with Micro-adjustment Screw. The Micro-adjustment
Screw will allow fine adjustment of the Adjustable Stop.
Setting the Fold Plate Adjustable Stop
ADJUSTABLE STOP
DOCUMENT
SHEET
FOLD ROLLER 2
FOLD ROLLER 3
FOLD ROLLER 1
BUCKLE OR
LOOP FORMED
IN DOCUMENT
SHEET
Micro-adjustment
Screw