GBR Systems M-40, Operator'S And Service Manual

Page: 148 / 161

M-40 OPERATOR & SERVICE MANUAL ISSUE 05/01 ADJUSTMENTS
SECTION D – PAGE 1
SECTION D ADJUSTMENTS
D.1 FEEDER.......................................................................... 1
D.1a Centering of the Feed Belt..................................................................... 2
D.1b Setting Feed Belt Tension ...................................................................... 2
D.1c Auxiliary Feed Belts............................................................................... 2
D.1d Singulating area ..................................................................................... 3
D.1e Positioning the Singulator Side Rails ................................................... 3
D.1f Singulator Roller.................................................................................... 3
D.2 FOLDER .........................................................................6
D.2a Folder Plates ........................................................................................... 6
D.2b Standard Folds ....................................................................................... 7
D.2c Folder Roller Tension Adjust.............................................................. 11
D.2d Perforating Knives............................................................................... 11
D.2e Exit Conveyor....................................................................................... 12
D.2f Side Glue Application Adjustment ..................................................... 12
D.2g Flap Glue System Adjustment ............................................................ 13
D.2h Sensor Adjustment............................................................................... 13
D.1 FEEDER
Mechanical adjustments may be necessary when changing document types
or if document-handling errors persist.
Follow the step sequence provided here to save time and prevent repeating
an adjustment that has been already made.
The following items must be aligned in the center of the Feeder using a
scale. Because many of these parts are nearly an inch in width, the exact
center may be hard to determine. This problem can be avoided by making
the measurement from the outside edge of the part being centered, to the
inside of the frame. When the measurement from one side of the part to the
frame is equal to the measurement from the other side of the part to the
opposite side frame, the part is centered.
Feed Belt on Feeder
Feed Belt