GBR Systems M-40, Operator'S And Service Manual

Page: 11 / 161

M-40 OPERATOR & SERVICE MANUAL ISSUE 05/01 INTRODUCTION
071-27939-400 SECTION A – PAGE 5
A.2 SETUP
The SETUP key on the touchscreen display can be used any time the
conveyor or folder is running. The SETUP key allows the operator to
configure the M-40 for different run formats. The formats that may be
selected are:

Glue Compressor

Job

Creeper velocity

Sheets per hour w/o insr.

Feed mode

Batch count

Inserter mode
Operator Control Screen
A.3 EMERGENCY STOP
The EMERGENCY STOP is located near the folder. It is red in color and is a
“latching” switch. This means that once it is pressed, it remains off until reset.
When the EMERGENCY STOP is pressed, the 24-volt DC supplied to the
machine is removed. This causes all of the peripheral devices connected to
the PLC to turn off. Once the EMERGENCY STOP is depressed, the M-40
stops processing paper immediately. To start the machine processing paper
again, the operator must reset the EMERGENCY STOP by rotating the stop
button in the direction of the arrows. Lifting either of the interlocked covers
will also stop the machine. To restart after a cover has been lifted, the cover
must be put back down.
Emergency Stop Button
E
G
R
E
M
E
N C
Y
T O
P
S