GBC OORCA-III, Operation Manual

Page: 22 / 109

ORCA-III Operation Manual Operation

GBC Pro-Tech 1997 October
3-3
2SHUDWRU &RQWUROV
The operator controls for the ORCA-III Laminator
are located on the front and rear of the unit, to the
right of the operator position. The names and
functions of these controls are as follows:
2SHUDWRU &RQWUROV
The operator controls for the ORCA-III Laminator
are located on the front and rear of the unit, to the
right of the operator position. The names and
functions of these controls are as follows:
)URQW &RQWURO 3DQHO
STOP
AUTO
FWD
REV
POWER
1
O
HEAT
ROLL
PRESSURE
MOTOR CONTROLS
PRO-TECH Engineering Madison,WI 608-246-8844
LAMINA
TOR ROLL
CONTROLS
20
100
40
80
Motor REV/REW
Motor Control
Switch
Lower Heater
Controller
Lower
Heater
ON/OFF
Speed Adjust
Upper Heater
Controller
Upper
Heater
ON/OFF
Main Roll Air
Pressure Gauge
Main Roll Up/Down
Switch
Fan/Vacuum
Table ON/OFF
Power
Light
SPEED
0
3
6
9
12
15
18
ADJ
TOP
1
O
BOTTOM
FAN TABLE
Speed Display
Main Roll Air
Pressure
Adjustment
2
3
4
5
7
8
9
10
11
13
12
1
6
Figure 3-1: Front Control Panel
1. SPEED DISPLAY - Provides digital readout of
the machine speed and total throughput in either
metric or standard units.
2. SPEED ADJUSTMENT - Adjusts the speed of
the machine from zero to maximum as the control
is turned clockwise.
3. UPPER HEATER CONTROLLER - Provides
a readout of the temperature of the upper
laminating roll and the set-point for the desired
temperature.
4. UPPER ROLL HEAT ON/OFF - Turns the
heater controller for the top laminating roll on or
off.
5. MAIN ROLL AIR PRESSURE GAUGE -
Displays the air pressure pushing the main
laminating roll down.
6. MAIN ROLL AIR PRESSURE CONTROL -
Varies the air pressure fed to the cylinders that
drive the top laminating roll down.
7. POWER LIGHT - Indicates when the main
power is being applied to the machine.
8. FAN/VACUUM TABLE ON/OFF - Turns the
vacuum table on or off.
9. MAIN ROLL UP/DOWN - Sets the main roll
to the up (load) or down (operate) position.
10. LOWER HEAT ON/OFF - Turns the heater
controller in the bottom laminating roll on or off.
11. LOWER HEATER CONTROLLER -
Provides a readout of the temperature of the
bottom laminating roll and the set-point for the
desired temperature. The upper heater must be on
for the lower heater to function.
12. FOOTSWITCH/CONTINUOUS RUN -
Changes control of the machine drive from the
footswitch to continuous run.
13. MOTION CONTROL FORWARD/STOP
REVERSE - Controls the direction of the drive
system - forward, stop, or reverse.