Page 5 - 17
Operations
F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
INFORMATION
When storing parameters within the JOB
SAVE feature of the laminator, PRESSURE
is not a storable setting.
f) Enter a desired speed by pressing SPEED
▲
.
S P E E D
SAFETY
F W D
R E V
5.0
G O
S T O P
g) Press and hold SAVE ( approximately 4
seconds ) until an audible beep is heard. The
parameters entered have just been stored.
J O B
STANDBY
SEL
S A V
1
h) Repeat steps “b” through “f” to save other
parameters in job location numbers.
CAUTION
If you accidentally press SAVE at any time,
the old parameters will be replaced with the
new parameters.
INFORMATION
You should store each job location with its
parameters on the chart provided in
Chart 5.4.1
Chart 5.4.1 Job save chart
BOT. TEMP.
JOB #
TOP TEMP.
GAP
SPEED
1
2
3
4
5
6
7
8
9