![background image](http://html1.mh-extra.com/html/gbc/f-160-ce/f-160-ce_operation-and-maintenance-manual_3938449064.webp)
Page 5 - 7
Operations
F - 160 CE Operation and Maintenance Manual
© GBC Films Group April 2000
INFORMATION
When the safety shield is in the lowered
position and "Footswitch" mode is
engaged, speed is controlled through
the control panel
Footswitch to Panel
2. To switch from “Footswitch” mode ( GO is flashing )
to “Panel” mode ( GO is solid ) with the safety
shields in the down position. Perform the following
steps;
• Press and hold the variable speed footswitch
down.
• Press and hold GO for 3 -4 seconds before
releasing the variable speed footswitch.
• Release the variable speed footswitch.
• Release GO. GO should be solid.
3. In the event that the safety shield must be raised
while the laminator is running, Perform the following
steps;
INFORMATION
If the variable speed footswitch is not
close to the speed of the control panel,
output quality may be affected by the
speed difference.
To raise the safety shield
W A R N I N G
When operating the laminator using the
variable speed footswitch, keep hands and
fingers away from the nip of the rollers.
Y o u m a y b e C R U S H E D o r B U R N E D !
• Press and hold on the variable speed footswitch.
( approximately 1/2 the travel distance of the
variable speed footswitch )
CAUTION
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.