5
6---- Cooling fan : Can lower the temperature of inverter. Should keep it clean during the inverter working.
7---- Positive terminal : connect with the positive (+
）
side of the battery.
8---- Negative terminal: connect with the negative (-) side of the battery.
9---- Ground terminal : connect to the ground , counseling electrical power.
NOTE: Protection fuses are located inside the inverter cabinet.
Output wave form:
The inverter is capable of continuously powering most 220-240V AC products that use the rated continuous output power
or less. Its AC output waveform, called
pure sine wave
It is designed to function as the sine wave shape of utility power.
5. Installation Guidelines
Selecting a suitable location
For safe and optimum performance. Install the inverter in a location that is…
Dry
. Do not expose to water drip or spray.
Cool
. Better to be used in ambient temperatures between 0°C and 40°C. Keep away from furnace heating vents or
other heat producing equipment.
Well ventilated
. Allow at least 5cm clearance above and on all sides of the unit for proper cooling.
Safe
. Do not install inverter in a compartment with non-sealed batteries or flammable liquids, such as gasoline, or
explosive vapors.
Clean and free of dust and dirt
. This is especially important if the inverter is used in a work environment.
Due to limitations in the common 12V/24V outlet in a vehicle or boat, the inverter should only be used to supply AC power
which is below the inverter rated power .
1. Before connecting your new inverter, you should make a visual inspection to ensure no visible damage has been
caused by shipping. Then make sure the Main Power Switch of the inverter is Off (O).
CAUTION! A reverse polarity connection (positive to negative) may damage the inverter. Damage caused
by a reverse polarity connection is not covered under warranty.
2. Tighten the nut on each DC terminal by hand until it is snug. Do not over tighten.
3. Insert the plug of this cable into the 12V/24V DC outlet and switch the unit ON. See Section 4 if the inverter does not
operate properly after being connected.
4. When the inverter is not in use, unplug it from the 12V/24V DC outlet to prevent slight discharge of the battery.