17
ENG
3M scotch tape mount installation
Warning!
1
2
3
4
5
Unscrew the nut of the
vacuum mount and detach the lower
and upper parts.
Use the screw and the nut from
package to securely attach
both parts.
Connect the bottom of the vacuum
mounting with 3M scotch tape.
Attach the frame of the recorder
to the 3M scotch tape mounting.
Wipe the surface of the windshield before installing.
Make sure the place is dry and clean. Do not install the mount on
3M scotch tape at temperature below +5°C. Because of such low
temperature and the difference between the temperature inside
the car and outdoors, the 3M scotch will lose its adhesive proper-
ties and will not be able to fix the mount properly.
Prior to installing, determine the exact
MVR position on the windshield. Mark
the installation place. Remember that
once the mount is installed on the car
windshield, you cannot change the
horizontal position of the device (side
to side), only vertical position (up and
down) can be changed afterwards.
Should your package include a single wide strip of 3M
scotch tape instead of 4 narrow ones, please follow the
installation instructions provided above.
Note:
3M scotch tape mount installation
Make sure that the device is installed
in a position from which hit can
be conveniently removed later.
Fix the mount so that other objects
do not prevent you from easily
removing your recorder.
Attach the 3M tape on the mount
by removing the protective film
on one side of 3M tape.
Double check that you have chosen
the best location to install the mount.
Remove the second protective film
from the 3M tape.
Attach the 3M mount to the recorder
on the windshield.
To remove the 3M tape mounting
from the windshield, take a ruler
or a credit card and push it gently
between the mount and the windshield.
