Gateway 710XL, User Manual

Page: 216 / 278

208
Chapter 11: Upgrading Your Computer
www.gateway.com
7
Install the new card into the add-in slot. You can slightly seesaw the card
end-to-end to help insert the card, but do not bend the card sideways.
8
Secure the add-in card with the retention screw.
9
If you disconnected any cables, reconnect the add-in card cables using your
notes from
Step 3 . See the add-in card documentation for further
instructions.
10
Close the case by following the instructions in “Closing the case” on
page 196 .
11
See the documentation that came with the add-in card for any special
software installation instructions.
Installing memory
When you upgrade the computer memory, make sure that you install the
correct type of memory module for your computer. Your computer uses DIMM
memory.
To install or replace DIMM memory:
1
Remove the side panel by following the instructions in “Removing the side
panel” on page 192 .
2
For more stability, place your computer on its side. To avoid scratching
the case, place it on a towel or other non-abrasive surface.
Warning Do not touch the contacts on the bottom part of the add-in
card. Touching the contacts can cause electrostatic
damage to the card.