Gastroback Design Automatic Bread Maker Advanced, Operating Instructions Manual, Page: 13 / 66

13
use violence!
Do not clean the appliance or any part or accessories of the appliance in
an automatic dishwasher.
1. Unplug the appliance and with the lid open, leave the appliance cool down to
room temperature (at least 20 minutes).
2. To unlock the bread pan, turn it counter-clockwise. Then lift it out of the heating
compartment.
IMPORTANT:
Only use warm dishwater for cleaning the appliance. Handle the
parts of the appliance with care to avoid damage. This holds especially for the inner
flap of the ingredients box, the white silicone seal on the bottom of the heating com-
partment and the heating elements.
3. Clean the heating compartment using a wet cloth or a slightly wet soft sponge.
Ensure to remove all crumbs and splashes. However, ensure not to damage the
white silicone seal and heating elements in the bottom of the heating compartment.
Additionally, no fluffs or other particles may remain on the heating elements.
4. Wipe the lid and the interior of the ingredients box carefully with a wet cloth.
Ensure not to damage the hinges of the inner flap of the ingredients box. If
required, use a small soft brush to clean the interior of the ingredients box.
5. Wipe the exterior of the appliance and power cord with a soft damp cloth. The-
reafter, wipe the appliance dry with a soft cloth.
6. Take the kneading paddle out of the bread pan by simply pulling it upwards.
If the kneading paddle sticks to the drive shaft and is hard to remove, fill
the bread pan with hot dishwater for approx. 30 minutes. Then try again. If
required, use the provided hook to lift the kneading paddle out of the bread pan.
7. Clean all surfaces of the bread pan and the kneading paddle using warm dishwa-
ter and a soft brush or cloth. Especially the drive shaft protruding from the bottom
of the bread pan interior needs thorough cleaning. It must be smooth and shiny.
Otherwise, the kneading paddle could stick to the drive shaft after next operation.
Tip:
Ensure that the opening in the kneading paddle is completely clean and smooth.
Residues within the opening would stick to the drive shaft, thus making it quite dif-
ficult to remove the kneading paddle from the drive shaft after operation.
8. After cleaning, hold the kneading paddle and bread pan up to the light to check,
whether the opening in the kneading paddle and the drive shaft are clean. If
there are any residues, you should soak kneading paddle and bread pan for
some minutes in hot dishwater. Thereafter clean thoroughly, using a soft cloth.