26
Appendix
1:
DESCRIPTION OF THE OPERATION AND OPERATING MODE OF
THE CONTROL PANEL WITH SITEC - TIMER 72x144
ELECTROMECHANICAL
ATTENTION!
The manufacturer reserves the right to change its machine models if it is considered necessary to improve the product.
Therefore, when inquiring about technical support and spare parts, always state:
•
Model number and machine type
•
Serial number
•
Position, description, part number and quantity of required spare parts
For additional information on the operation of the machine, please contact the manufacturer.
All the controls needed to operate this machine model are located on the control panel, as shown in the
figure.
shown below. The specific function of each knob and selector switch is clearly indicated by graphic symbols
located on or near each controller.
The illustration shows the control panel of the two-speed model, which is located on the front of the
machine's head cover. The knobs of the first gear (knob I) and second gear (knob II) are installed in a single
timer with the dimensions 72 x 144 mm.
