8
In all modes except
standard servo
, the selection of the desired channel for each
function is done through the +/- buttons. In the picture, the Gear will be the CH5, the
brake the CH6 and steering the CH4.
Once the RC Mode is selected and the channels assigned, now you should adjust the
endpoints for the Gear channel and for the Brake Channel. Touch the
RC SET
button.
This will drive you through the alignment sequence.
Screens are self-explaining, just follow the instructions. If during the radio alignment
there isn’t a valid RC signal on
Brake IN
input, the system will assume that it should
work in single channel mode, and will expect that the defined position for the gear
down command be at an intermediate point between
Gear Up
and
Maximum brake
. For
example,
Gear Up
1.000us,
Gear Down
1200us,
Full brake
2000us.
