Use a cotton bud, tooth brush, or some other item to
clean out any incrustations or dirt from the four holes
marked(H) The spark gas is 4-6mm. Replace burners
and ensure they are correctly repositioned over the
ignitor (S) and thermocouple (T). The ignitor (S) must
be clean for trouble free sparking. Test burner ignition
and burner flame for correct operation.
The Triple Ring (Wok) burner (diagrams below) does
not fit over the ignitor or thermocouple but must be
placed on its supports. If burner is placed correctly
it will not rotate on its supports. The surface of cooktop,
Ignition Pin(S), Thermocouple (T) and burners need
to be cleaned after each time they are used with warm
soapy water, rinsed and then dried well to keep them
in good condition.
Never clean when the top and components are still warm. Do not use metal
or abrasive pads, abrasive powders or corrosive spray products. Never leave
vinegar, coffee, milk, salty water, lemon or tomato juice for any length of time
on the surfaces.
• To replace gas and electrical components, that are lodged inside the cooktop, it
is enough to remove the work top unscrewing the fixing screws of the burners.
• Replace the seal each time you change a tap in order to guarantee a perfect
tightness between body and rail.
Trouble shooting
Servicing of the cooktop must only be done by an authorised service
representative and the cooktop must not be modified. Power must be
disconnected before any servicing or maintenance is conducted.
DO NOT MODIFY THIS APPLIANCE.
It is recommended the cooktop serviced by an authorized person at least
every 2 years. This service is not covered by warranty.
Abnormal conditions include:
• Excessively yellow or sooting flame type.
• Flame lifting off the burner ports.
17
Australia:
1(844) 538-7890
www.gaslandchef.com
[email protected]
www.gaslandchef.com.au
United States: