Mechanical Interface Option
Wiring Diagrams
Page 42
MDE-4319A TopKAT Fuel Managment System Installation Manual · November 2005
Wiring Diagrams
Figure 5-4: Wiring Diagram: Veeder-Root
®
Reed Switch Pulser, 1871 Series 10:1
Figure 5-5: Wiring Diagram: Veeder-Root Electronic Pulser, 7671 Series 100:1
Pulser Wiring Notes
1
All pulsers above are shown connected to hose 1.
2
Jumpers on the Pump Control PCB must be properly jumpered according to the pulser type.
This should be done by the person performing the start-up. Power to the system must not be
turned on prior to this set-up.
3
See
for detailed system installation specifications.
4
When installed in a separate DC conduit, 18 AWG wires are required for installation.
Although it is recommended that DC pulser wires be run in a conduit separate from AC wires,
they can be combined in the same conduit with AC wires providing UL-Listed cable with the
following specifications is used: