GARO TFA4500-3D, User Manual

Page: 21 / 40

USER’S MANUAL
-
17
-
Fig. 38
Install the lowering micro-switch to the bottom of the post
as shown in
Fig. 39 .
Fig. 39
Install the warning buzzer to the top of the post according
to
Fig. 40 .
Fig. 40
Position the posts at the end of the cross-pieces observing
the numbering and the lay-out shown in
Fig. 32 .
Fit the safety rods (Fig. 41-1) from the top of the posts,
inserting them between the rear face of the cross-pieces and
the guide pins
(Fig. 41-2) as shown in Fig. 41 .
Fig. 41
Check the Safety rods are straight.
Fit the Safety rods with the rounded edges of the slots
towards the front of the posts.
Now secure the bottom end of the rods as shown in Fig. 42 .
Fig. 42
Remove the nuts and washers from the ends of the lifting
cables and install the terminal blocks in the relevant holes
on the top plates of the posts
(Fig. 43) .
Fig. 43
Screw the nuts and washers onto the terminal blocks.
During this procedure, make sure that the cable wheel of
the safety wedge are correctly positioned on the lifting
cables as shown in
Fig. 44 .