GARO TFA4500-3D, User Manual

Page: 20 / 40

USER’S MANUAL
-
16
-
Fig. 34
When you are installing the cross-piece, fit the wedge
control rod between the two cross-pieces; the rod is
engaged on side “A” and fastened on side “B” by M6 x 20
screws and 6 x 12 plane washers
(Fig. 35) .
Repeat this operation for the cross-piece (Fig. 32-6).
Fig. 35
4.2 POST ASSEMBLY
Remove the safety rods from the top of the posts as shown
in
Fig. 36 .
Fig. 36
Preparation of the control post
The control post is distinguished from the others because it
has drilled holes to receive the control panel and the
hydraulic power unit.
Secure the hydraulic power unit and control panel to the
control post.
(Fig. 37)
Fig. 37
Install the lift limit switch on the top inside of the post
according to
Fig. 38 .