Garmin GPS 400W, Installation Manual

Page: 209 / 212

GNS 400W Series Installation Manual Page H-53
190-00356-08 Rev. G
P881
GDL 88/88D
GNS 400W SERIES
P4001
TIME MARK OUT 16
s
22(28) TIME MARK 1A(2A)
DUAL GNS 400W SERIES
GPS RS232 OUT 1
GPS RS232 IN 1
56
57 26 RS-232 IN 2
RS-232 OUT 2
7
45 RS-232 GND 2
s
P881
GDL 88/88D
GNS 400W SERIES #1
P4001
GPS ARINC 429 IN 1A
GPS ARINC 429 IN 1B
48
49
10 ARINC 429 OUT 1A
29 ARINC 429 OUT 1B
s
5
GNS 400W SERIES #2
P4001
TIME MARK OUT 16
s
28 TIME MARK 2A
GPS RS232 OUT 1
GPS RS232 IN 1
56
57 21
RS-232 IN 5
RS-232 OUT 5
2
40
RS-232 GND 5
GPS ARINC 429 IN 1A
GPS ARINC 429 IN 1B 48
49
s
8
4
TIME MARK OUT 16
s
22 TIME MARK 1A
GPS RS232 OUT 1
GPS RS232 IN 1
56
57 26 RS-232 IN 2
RS-232 OUT 2
7
45 RS-232 GND 2
s
8
GPS ARINC 429 IN 1A
GPS ARINC 429 IN 1B 48
49 10 ARINC 429 OUT 1A
29 ARINC 429 OUT 1B
s
5
6
7
4
7
7
SINGLE GNS 400W SERIES
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. GROUND DESIGNATIONS: SHIELD BLOCK GROUND AIRFRAME GROUND
3. AT THE GNS 400W, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL -- THE SHIELD LEADS MUST
BE LESS THAN 3.0". CONNECT OTHER SHIELD GROUNDS TO AIRCRAFT GROUND WITH AS SHORT A CONDUCTOR
AS PRACTICAL.
4. IF RS-232 PORT 1 IS ALREADY USED FOR ANOTHER PURPOSE, ANY RS-232 PORT MAY BE CONNECTED IN LIEU OF
PORT 1. REFER TO SECTION 5.3.2 FOR RS-232 PORT SETTINGS.
5. IF ARINC 429 OUT 1 IS ALREADY USED FOR ANOTHER PURPOSE, ANY ARINC 429 OUTPUT PORT MAY BE
CONNECTED IN LIEU OF ARINC 429 OUT 1.
6. EITHER TIME MARK 1A (P881-22) OR TIME MARK 2A (P881-28) MAY BE USED.
7. CONFIGURE THE GDL 88 RS-232 IN PORT SETTING TO 400W/500W SERIES #1 WHEN THE CONNECTED GNS 400W
SERIES TIME MARK OUTPUT (P4001/P5001-16) IS CONNECTED TO GDL 88 TIME MARK 1A (P881-22). CONFIGURE
THE GDL 88 RS-232 IN PORT SETTING TO 400W/500W SERIES #2 WHEN THE CONNECTED GNS 400W SERIES TIME
MARK OUTPUT (P4001/P5001-16) IS CONNECTED TO GDL 88 TIME MARK 2A (P881-28).
8. IF GPS ARINC 429 IN 1 IS ALREADY USED FOR ANOTHER PURPOSE, GPS ARINC 429 IN 2 MAY BE CONNECTED IN
LIEU OF GPS ARINC 429 IN 1.
9. IF THE GDL 88 IS INSTALLED WITH ANOTHER TRAFFIC DEVICE, THE OTHER TRAFFIC DEVICE SHOULD BE
DISCONNECTED FROM THE GNS 400W AND CONNECTED TO THE GDL 88 INSTEAD. REFER TO THE GDL 88 STC
INSTALLATION MANUAL FOR ADDITIONAL DETAILS.
s
NOTES:
4
8
9
9
Figure H-41. GDL 88/88D Interconnect